Recent content by wael gano

ا good Can you smoke GHB?

Is the bark of the roots only Or stems and branches You mean the root that grows down into the soil

Good The excess acid evaporates as the ethanol evaporates. I can wash it to remove some impurities

باستخدام الكاميرا Combine methylamine hydrochloride with sodium hydroxide in alcohol with balanced molar ratios of 1/1. You will notice a strong smell of methylamine and the appearance of a sodium chloride salt precipitate. At this stage you can add P2P oil and stir it for a while while closing...

My base was dissolved in ethanol After pumping hydrogen chloride gas, this is the result. I am fine with this color

Borohydride is a good reducing agent Make sure it is pure copper chloride I suggest you react p2np with aluminum amalgam. Try it in small quantities, starting with the correct amalgam. Add p2np in two stages and control the temperature of the amalgam. Extract the free base with isopropyl alcohol

Yes, correct If a transparent or slightly yellowish oil layer does not form in the separating funnel, it is important to see an oil layer when extracting the base. If you don't see this, you won't have a free amphetamine base (maybe you reacted wrongly). There is a concern about the tin chloride...

You can re-extract the basic acid of this salt that you obtained Dissolve this salt in cold water, the ratio of water to salt is 1/1 Add 25% sodium hydroxide solution dropwise to pH12 You will notice an oily layer on top Add the DCM solvent, mix it well, then throw it into the separating...

After alkalinity is carried out, the pseudoephedrine base is dissolved in the toluene. Separate the toluene from the water, then add clean distilled water to the toluene and separate it a second time to remove the sodium particles. Then pump Hcl gas to the toluene. The pseudoephedrine Hcl salt...

Yes, Hcl gas

Dissolve it in alkaline water, pH 12, then extract it with toluene or xylene Then wash the toluene with water once, taking care that the alkalinity does not decrease. Then separate the toluene and pump hydrogen chloride gas into the toluene. The crystals of pseudoephedrine hydrochloride will...

I had no problems with acid-base extraction All you have to do is add acid and extract with solvent Then add the alkali, extract again and combine the extracts together

The translator made a mistake in writing I did not do that I mean this picture, after the acid-base extraction and the second alkaline extraction, I had a free base in Dcm solvent, its color was light yellow, and I pumped hydrogen chloride gas to it, and the color became pink.

Amalgam is good I mixed the base, ethanol, and formaldehyde together and added them to the amalgam. The amalgam was not violent, and when stirred, slight bubbles appeared, and the amalgam became thick like dough. I added formaldehyde a second time. Some of it had evaporated while heating the...

Sorry I read in another synthesis of yours You evaporate Dcm and add ethanol to the base, then the gas But okay if the free base of meth in the solvent is Dcm Adding hydrogen chloride gas is normal, so I can do this